DATA SHEET

Count:              12 x 12 tapes/inch

Weight:             5.3 ounces per square yard (164 grams)

Tensile Strength:   Warp – 194.8 lbs.               ASTM D751 (Meth. A)                                          (Grab Method)                           

                    Weft – 188.2 lbs

Tear Strength:      Warp – 41.3 lbs.                ASTM D4533 (Meth. B)                                        (Tongue Method)               

                    Weft – 42.1 lbs.

Mullen Burst:       372 p.s.i.                    ASTM D751

Coating Thickness:  2 mil average each side

Overall Thickness:  9 mil average

Scrim Type:         Clear Tapes, UV stabilized

Color:              Clear

Accelerated         More than 80% strength        ASTM G53-84

Weathering/U.V.:    retension after 2000 hours 

(Q.U.V.[A-340 Lamps] 8 hrs. U.V. @ 60 deg C./4 hrs condensation @ 50 deg. C)

Width:              Up to 144 inches

THESE VALUES ARE TYPICAL DATA AND ARE NOT INTENDED AS LIMITING SPECIFICATIONS.

WindLift 5000 lb. Electric Ceiling Winch Specs

• 9' power cord & 9' controller cord
• Holds approximately 64' of 3/16" cable
• Recommended 2:1 double-back for loads exceeding 2500lbs.
• 5000 lb. rated capacity based on the first layer of cable or strap around the drum.  Additional layers reduce capacity.
• New manual override option



 

*Please note this winch is designed to pull in two directions.  Pulling in one direction voids the warranty. Please see our Cable and Winching Guidelines page for more information.

*Gears must be greased before each cycle. When using drill cranks to raise and lower winches, drills should only be operated at low speed. High-speed operation will damage gears and void any warranty.

XF966 8” EGG BELT DATASHEET

These values are typical data and are not intended as limiting specifications

DS 03/97

XF966 Egg Belt Data Sheet

•         Coating - Epoxy coating is electrostatically applied and then oven cured to provide continuous coverage on all surfaces at 3-5 mils thickness.

•         Steel - Grade C 1008 cold drawn steel rod
PSY 100,000 tensile strength.  Line wires are .160 in. (4.0 mm) and cross wires are .091 in. (2.3 mm) at a gap distance of .53 in. (13.4 mm).

•         Installation - Starting at one side of house, layout lengths overlapping 2”- 4” between sections to lock in. (More than 4” acceptable to avoid cutting and does not reduce ventilation properties).  Water/ feed lines– use bolt cutters to cut out vertical wires and top cross wire to drop in water lines.